REPAIR GUIDE
       Back to Keystone Price List

1. Installation of a rigid shank on top of a Superfit may impair its resiliency Wider shanks in particular may be rendered inoperative. Wider rings under size 5¼ should be tapered to increase spring tension and ease opening and closing.

2. If there is resistance in closing, check if tongue is flush with inside radius and centered. Both extension balls should make a uniform contact before closing.

3. If the spring tension is fading without abusive wear, check for cracks in metal or weakness within the top section. If the problem persists, a wider shank will provide more resistance against bending stress.

4. If the latch is depressed and returns to a closed position, check if the tongue is flush with inside radius. Otherwise, stretch the tongue at the end area a hair at a time until it works.

5. If the latch does not trigger a separation, it could be dirt between the latch tail and bottom shoulder. If the ring is on the customer's finger, soak in warm water. Afterwards, depress the latch while pulling apart the shank to overcome the frictional hold.

6. If the latch slips out during a pull test, redress the hook cavity wall and bend down the latch hook very slightly.

7. If the latch hook is bent down too far and is hard to open, slide the ring over the mandrel, guide the interlock over the mandrel groove and pull down gently until you see a separation gap of under .020, enough to straighten the latch hook. Handle with care to avoid metal distortions

8. When the Superfit is delivered to customers or sent out for plating, polishing, stone setting or engraving, make sure they are familiar with handling a Superfit and attach a warning note: DO NOT PULL AT THE LATCH!! If the latch has been abused and must be replaced, it is not covered by the warranty.